Anchor-Seal Tin Series RTV-2 Silicone Rubber
Condensation cure, no cure inhibition, cast epoxy, polyester, and polyurethane, molds for prototype parts, electronic potting, glove molds.
Specialty Type Products
All activators are available in clear.
Standard Tin and Platinum Series mix ratio is 10:1 by weight, excluding P-17 Black, P-17 Black is 1:1.
All Tin Series products have a minimum of 6 month shelf life.
Tin Series products cure in 16-24 hours @75F.
Mixing ratio is 10 parts of Base to 1 part of Activator by weight, excluding P-17; P-17 as shown is a 1:1 ratio. Deviations from the specified mix ratio will cause changes in the physical properties. Choose a container with a volume that is three to four times greater than that of the rubber. Weigh the components carefully and mix thoroughly while simultaneously scraping the sides and bottom of the container to insure that there is no unmixed portion. Place the container in a vacuum chamber and deaerate at 28 to 29 inches of mercury vacuum until the mass of rubber rises and then collapses. Remove the mixed rubber and carefully pour over mold, MR-15 is recommended for GI and Platinum molds.
* Translucent Base available